Wiring Mercury Magnetics for Ceriatone OTS 50
Moderators: pompeiisneaks, Colossal
-
- Posts: 1
- Joined: Fri Feb 23, 2024 9:53 am
Wiring Mercury Magnetics for Ceriatone OTS 50
I'm replacing the power transformer in my Ceriatone OTS 50 with a Mercury Magnetics CER-OTS550-P and don't know what to do with wiring the 60V bias supply. There are two gray leads. I don't know whether to float one end or ground it and don't want to blow anything up. I attached the Wiring diagram from Mercury. Any help is greatly appreciated!
Re: Wiring Mercury Magnetics for Ceriatone OTS 50
I don't see any attachment - try again.
cheers,
cheers,
Jack Briggs
Briggs Guitars
Briggs Guitars
-
- Posts: 196
- Joined: Sat Sep 28, 2013 2:25 pm
- Location: Denmark
- martin manning
- Posts: 13287
- Joined: Sun Jul 06, 2008 12:43 am
- Location: 39°06' N 84°30' W
Re: Wiring Mercury Magnetics for Ceriatone OTS 50
It's a separate winding, exactly as shown in the C-tone layout. Ground one side and connect the other to the bias supply.
https://www.mercurymagnetics.com/wp-con ... TS50-P.pdf
https://ceriatone.com/wp-content/upload ... ial-V2.jpg
https://www.mercurymagnetics.com/wp-con ... TS50-P.pdf
https://ceriatone.com/wp-content/upload ... ial-V2.jpg