The Amp Garage

Longshot, but does anyone have experience with 12" Weber alnico speakers not fitting in a low power mojo tweed twin cab? The speaker measures 6 1/4" in total depth, cab is 10 1/2". Concerned it will hit the preamp tubes. I can call mojo on Monday for advice, perhaps they can tell me if I will have a...

Once again proving I know just enough (or don't know plenty) to be dangerous. A ground lug would have been best, but red/yellow and gree/yellow to ground is correct? [img:1000:750]http://kurtsequipment.com/twin5e8a/twin3.jpg[/img] Edit: oh and thank you for the compliments! I'm sad it's over but REA...

No center tap on this guy, correct?

http://www.mojotone.com/transformers/Fe ... OJO752.pdf

Oo, thank you for that. I will install them!

Done except for the cabinet and power tubes. Anyone notice anything glaringly wrong? It's mostly parts from Tubedepot and Mojo + stuff I had in my parts bins, and a proper Heyboer PT. Speakers are Weber 12A150 with repro labels that I'll wire for 4 ohms. Going to use EH rectifier tubes, TAD short bo...

Exactly what I got, thank you. I'll post some pics when I'm done. It's been a fun project. I've only built British amp clones.

I measured and it was .5 meg. Maybe because I don't have all the connections on the first jack soldered, they're only physically wrapped on the terminal. Is the Weber inputs' layout here a good visual reference?

http://taweber.powweb.com/store/5e8a_layout.jpg

Thanks!

On the leftmost jack, the switch and ground are connected. I'm following this layout here for the inputs: http://taweber.powweb.com/store/5e8a_layout.jpg

I'll try your resistance suggestion!

Could someone verify my wiring so far, please?

Thank you!

Thank you! And is my wiring correct so far?

Again, thank you for the help.

Hi guys, I'm building a low power tweed twin, mostly from a Mojo kit, with some part swaps. My question is on the inputs. Do I have them wired correctly? Is there any need to run another ground wire from the ground lug to the chassis? I would think the physical connection to the chassis is sufficien...